Building a SSC Warbird Fuselage - Page #11


 Next a couple pieces around the tail support.
Next a couple pieces around the tail support.



Drill a hole in both sides of the plug for the sheet metal or sheet rock screw that will be used as the rubber band anchor.
Drill a hole in both sides of the plug for the sheet metal or sheet rock screw that will be used as the rubber band anchor.

 Start covering the fuselage with your favorite colored tape.
Start covering the fuselage with your favorite colored tape.

 Iron it down as you go and you'll get a clean smooth finish.
Iron it down as you go and you'll get a clean smooth finish.
Continue covering.
Continue covering.

 Trim around the servo shaft.
Trim around the servo shaft.

 Continue to iron as you go.
Continue to iron as you go.







An easy way to make a hole in the tape for the servo shaft is the hot brass tubing routine.
An easy way to make a hole in the tape for the servo shaft is the hot brass tubing routine.

Click on the thumbnail for a larger version!    

Page 1 | 2 | 3 | 4 | 5 | 6 | 7 | 8 | 9 | 10 | 11 | 12 | 13 | 14


© Lee Liddle & Roy S. Appleton, 2003
Saved June 5, 2003 12:18